XRAY X4 Upper Bulk Mount Plate Pair 1mm and 2mm Factory Pro O-XCP014  [FP-O-XCP014]

Price:
AUD$15.04
Brand:
Factory Pro
Model:
FP-O-XCP014
Condition:
Brand New
Write a review

Upper bulk mount plates made for X4

The Factory Pro O-XCP014 pack includes two upper bulkhead mount plates tailored for the XRAY X4 chassis: one 1mm plate and one 2mm plate, one piece each. These act as replacement or alternative thickness plates for chassis stacking and setup refinement.

They install at the X4 upper bulkhead while retaining the original fastener layout and mounting points; typically you remove the factory upper plate and reuse the OEM hardware. This set makes it easy to tweak stack height and adjust front to rear geometry without swapping major parts.

Carry these plates for on-the-fly setup trials or keep as spares for maintenance. They are specified for RC-scale chassis tuning and do not indicate any full-size vehicle application.

Can I use these plates on earlier X4 variants?

They are intended for the XRAY X4 layout where an upper bulkhead plate is mounted. Check that your older variant shares the same upper bulkhead mounting pattern before fitting.

What are the practical benefits of 1mm vs 2mm?

The thinner plate slightly reduces stack height and can loosen steering response, while the thicker plate raises the stack for a firmer front end. Use lap comparisons to determine the right feel.

Will fitting these affect other suspension settings?

Changing stack height can alter geometry and affect camber and toe under load. After swapping plates, recheck suspension setup and perform short test runs to validate changes.

Copyright © 2008-2026 rcjaz.com.au All rights reserved