For HELIX and ICON control - Yokomo FA-19219 FANTOM sensor board (26mm rotor)  [FA-19219]

Price:
AUD$52.52
Brand:
Yokomo
Model:
FA-19219
GTIN:
639342200849
Condition:
Brand New
Write a review

Sensor board role in sensored control

This replacement sensor board is intended for the FANTOM motor family and fits motors designed for a 26mm rotor. It supplies the sensor signals required for sensored operation when paired with HELIX, HELIX V2, ICON V2, ICON V3 and ICON-Torque variants. Note that the board restores electronic feedback and does not alter mechanical motor specifications.

Installation demands matching the correct board variant to the motor and aligning connector pins to the motor harness; confirm part orientation and connector type before applying power. As a component-level replacement, inspect all solder joints and connector contacts on the motor and ESC, and use an ESD-safe workspace.

From a tuning perspective, the board does not change RPM or torque but is essential for ESCs that rely on precise rotor position signals; if performance symptoms persist after replacement, review ESC sensor mode and timing adjustments.

Specifications

  • Item Sensor board replacement for FANTOM motor, for 26mm rotor motors
  • Material Not specified
  • Model Number FA-19219
  • Compatibility FANTOM motors used with HELIX, HELIX V2, ICON V2, ICON V3, ICON-Torque; supported chassis FA-19113S, FA-19117S, FA-19221S, FA-19013S, FA-19017S, FA-19021S, FA-18913, FA-18917-6

Use the Yokomo FA-19219 board to replace defective sensor modules in sensored FANTOM motors, then verify ESC settings and run sensor checks to ensure accurate closed-loop motor control.

Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will installing this board affect motor timing or throttle response?

The board only restores position feedback. Any change in throttle feel or timing will result from ESC settings once the ESC receives proper sensor signals; check and adjust timing if needed.

Is FA-19219 compatible with my ICON V3 motor?

Yes, the FA-19219 is listed for use with ICON V3 as long as the motor uses a 26mm rotor and the connector type matches the board.

How should I verify sensor signal integrity after fitting?

Use an ESC sensor test or an oscilloscope to confirm three-phase sensor outputs while slowly rotating the rotor; irregular or missing pulses indicate connection or board faults.

Can this board be used to troubleshoot intermittent sensor faults?

Yes. Swapping the board can isolate whether the fault lies in the sensor module versus the motor windings or ESC wiring. Perform bench tests to confirm.

Do I need to recalibrate ESC settings after replacement?

A full recalibration is not always required, but you should confirm sensor detection, check timing, and run the motor at low speed to ensure stable feedback before normal use.

Are there common failure modes to watch for on these boards?

Common issues include damaged connector pins, cracked solder joints, or contaminated contacts. Inspect these areas first when diagnosing sensor problems.

Copyright © 2008-2026 rcjaz.com.au All rights reserved