For Kyosho Mini Inferno Delrin 16T Motor Gear DMIF016T by GPM  [DMIF016T]

Kyosho Mini Inferno Delrin Motor Gear (16T) - 1pc set - GPM DMIF016T
Price:
AUD$2.15
Brand:
GPM
Model:
DMIF016T
GTIN:
4894538045161
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review
alt="Kyosho Mini Inferno Delrin Motor Gear (16T) - 1pc set - GPM DMIF016T" title="Kyosho Mini Inferno Delrin Motor Gear (16T) - 1pc set - GPM DMIF016T"
alt="Kyosho Mini Inferno Delrin Motor Gear (16T) - 1pc set - GPM DMIF016T" title="Kyosho Mini Inferno Delrin Motor Gear (16T) - 1pc set - GPM DMIF016T"
alt="Kyosho Mini Inferno Delrin Motor Gear (16T) - 1pc set - GPM DMIF016T" title="Kyosho Mini Inferno Delrin Motor Gear (16T) - 1pc set - GPM DMIF016T"

Delrin 16T motor gear made for Mini Inferno

This is a single-piece Delrin motor gear intended for the Kyosho Mini Inferno platform, supplied as a 1pc set and identified by model DMIF016T. It is offered as a direct replacement option for scale RC drivetrains and matches the motor output interface commonly found on Mini Inferno cars.

Delrin (acetal) is used for its low friction and reliable wear characteristics on small drivetrain components, so this gear is appropriate for routine servicing or when altering gear ratios during tuning. The 16-tooth specification in the product name determines the final drive ratio when mated to the vehicle's pinion gear.

Installation is user-friendly for hobbyists: remove the motor according to your Mini Inferno maintenance routine, swap the original gear for this Delrin unit, and secure with the vehicle's original retainer. After installation check mesh and endplay, then perform a short low-load run to verify smooth engagement before full-power running.

Is this a direct swap for the Mini Inferno motor gear?

Yes, where the motor output and gear fitting match the Mini Inferno standard this gear will swap in as a direct replacement. Confirm shaft and mount compatibility first.

Should I change mesh settings when switching materials?

Always set mesh after fitting a new gear, as material thickness and tooth profile can alter the optimal clearance. Check under no load then run a slow test.

Will this gear affect battery or motor load?

The gear material itself has minor influence on load; gear ratio is the main factor. Use the correct mesh and monitor motor temperature during initial runs.

Copyright © 2008-2026 rcjaz.com.au All rights reserved