For Schumacher Mi10: Graphite 3.0 Rear Upper Body Mount - Setup Focus - O-SCP049 by Factory Pro  [FP-O-SCP049]

How the graphite upper mount affects Mi10 handling

This Factory Pro produced part is an aftermarket rear upper body mount made for the Schumacher Mi10 chassis, supplied as Factory Pro O-SCP049. The graphite 3.0 piece is intended for drivers who want to investigate how a stiffer upper body attachment alters rear balance and feedback.

Functioning as the upper rear securing point, the mount attaches the body shell to the Mi10 rear posts. Its increased stiffness relative to common plastics aims to provide clearer feedback to the rear end, helping to tune progressive changes in grip rather than sudden shifts.

Installation notes

• Remove the body shell and access the rear mount area on the Mi10 following your usual service routine.
• Slide the graphite mount onto the rear posts, making sure the mounting apertures match the chassis points.
• Secure with the chassis' existing fasteners and then check that the shell sits square and that clearance to the wing and suspension is retained.
• Run the suspension through full travel to ensure no contact occurs during compression and rebound cycles.

Tuning role

• The firmer graphite upper mount changes the way the body dumps load into the rear suspension, producing nuanced differences in rear traction and driver feel.
• Use it when comparing incremental setup changes, such as wing angle or body mounting points, to see consistent effects across runs.
• Adjust ride height and damper settings in concert with body-mount changes to maintain a predictable handling baseline.