Front Anti-Roll Upgrade for Cyclone CY-26/F, Machined Aluminium by 3Racing  [CY-26/F]

Purpose-built front stabilizer for Cyclone

The CY-26/F is a machined aluminium front stabilizer made as an aftermarket upgrade for Hot Bodies Cyclone Sport and Racing versions. It serves as a replacement for the stock front anti-roll component to modify roll stiffness and refine weight transfer in turns.

Constructed from machined aluminium, this stabilizer provides predictable stiffness at the front axle to influence steering balance without altering suspension geometry. It is intended for 1/10 electric on-road setups where fine tuning of front roll resistance improves tyre load distribution and steering response.

Installation is straightforward: remove the original stabilizer and mount the CY-26/F using the Cyclone's existing attachment points. Typical hex drivers are all that is required; check screw torque and alignment after installation. Verify free suspension movement and review adjustable end-link lengths if your chassis supports them.

Tuning notes: a stiffer front stabilizer reduces roll and can sharpen turn-in but might boost understeer at higher speeds. Softer settings increase front compliance and can help with turn bite on low-grip surfaces. Make measured adjustments and test under the same conditions to assess changes.