Front Chassis Brace for HPI Bullet 3.0 MT and ST - BUL-18004-BK by Jazrider  [BUL-18004-BK]

HPI Bullet - Black Alloy Front Chassis Brace
Price:
AUD$14.96
Brand:
JAZRIDER
Model:
BUL-18004-BK
Condition:
Brand New
Write a review

Front-end tuning brace for HPI Bullet

The black alloy front chassis brace is an aftermarket replacement sized for HPI Bullet platforms. It mounts to the forward chassis area of the Bullet 3.0 MT and ST (Nitro Engines) to reduce flex where the front bulkhead connects to the chassis.

Use this part primarily for chassis reinforcement and to influence handling rather than for looks. The stiffer alloy background gives a firmer base for adjusting front suspension geometry and steering feel during setup tuning.

To fit the brace, remove the existing front brace or reach the original mounting points, align the new alloy piece with the chassis holes, and reuse OEM screws if they match. Trial-fit components and cycle steering to ensure nothing interferes with the nitro engine or suspension before completing the job.

How does this brace change handling?

By stiffening the front chassis area, the brace reduces unwanted flex and gives a more consistent front-end response, which can make steering feel sharper and tuning more predictable.

Should I change suspension settings after fitting?

Small adjustments to toe, camber, or shock valving may be beneficial since the chassis will react differently with reduced flex. Test incremental changes to find the best setup.

Is this part suitable for track vs bashing?

It works well for both, but racers will notice handling consistency more. For heavy bashing expect higher stiffness to transfer more force to other components, so inspect mounts regularly.

Copyright © 2008-2026 rcjaz.com.au All rights reserved