Front Upright for Tamiya DT-03 - Aluminium Performance JR-DT306-RD by Jazrider  [JR-DT306-RD]

Tamiya DT-03 Aluminum Front Upright (Red)
Price:
AUD$12.64
Brand:
JAZRIDER
Model:
JR-DT306-RD
Condition:
Brand New
Available in shop
Write a review

High-Strength DT-03 Front Upright

This reinforced aluminium front upright is a direct-fit hop-up for the Tamiya DT-03 chassis and is listed as JR-DT306-RD. It replaces the OEM plastic component to give stronger front-end support and more predictable steering behaviour.

Fitting this upright uses conventional DT-03 suspension procedures and standard RC workshop tools; no special adaptors are required for the DT-03 mounting points. During installation, inspect ball joints and bearings for wear to keep steering smooth and reliable.

As an upgrade part, the aluminium upright reduces flex and helps maintain toe and camber under load, which translates to steadier turn-in and improved mid-corner consistency. It is targeted at racers and club drivers seeking durable, predictable handling gains.

Will this hold up better than plastic in club racing?

Yes. The aluminium construction resists flex and impact-related deformation better than stock plastic, improving longevity in regular track use.

Does upgrading uprights change suspension geometry?

The part maintains original DT-03 geometry; however, the reduced flex can alter steering feel and the car's response, so small tuning tweaks may be needed after fitment.

How often should I check fasteners after installing?

Re-check screws and ball joint security after your first run and periodically thereafter, as track vibration can loosen hardware over time.

Copyright © 2008-2026 rcjaz.com.au All rights reserved