FS-120S/FS-120S-E Gasket Replacement OS45514010 - O.S. Engine  [OS45514010]

O.S. ENGINES GASKET SET FS-120S,FS-120S-E
Price:
AUD$6.37
Brand:
O.S. Engine
Model:
OS45514010
GTIN:
4531028123052
Condition:
Brand New
Write a review

FS-120S series gasket repair kit

This O.S. Engine gasket set is a compact replacement kit made to renew sealing surfaces on the FS-120S and FS-120S-E RC engines. It is intended for routine service work to eliminate fuel leaks and maintain compression without changing the engine's rated performance.

Fitting is standard practice: remove the head or crankcase parts that require attention, lift out old or damaged gaskets, fit the matching parts from the set, and reassemble using correct torque on the fasteners. Always check and clean mating faces to remove burrs and old gasket residue prior to installing new seals.

In maintenance and tuning routines, fresh gaskets restore consistent running rather than improving power. Replace this set when you suspect compression loss, notice fuel seepage at joints, or after engine disassembly for piston or cylinder work.

Compatibility

Compatible only with O.S. Engine FS-120S and FS-120S-E models; verify the engine model code before purchase.

Replacing leaky or compressed gaskets restores proper compression and idle stability, which can change how the engine behaves; you may need to fine tune the needle or idle after service.
Typically no sealant is needed if mating faces are clean and flat; only use approved sealers if the service manual specifies them for your engine assembly.
Yes. Whenever you disassemble the piston or cylinder, fitting new gaskets is recommended to ensure consistent sealing and avoid future leaks.

Copyright © 2008-2026 rcjaz.com.au All rights reserved