6EXAP 6-Channel FM 72Mhz/ R156F Futaba [6EXAP_c13]

Price:

AUD$175.75

Brand:

Futaba

Model:

6EXAP_c13

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the
R/C Models - System - Transmitter - Flight Transmitters category

Write a review

Description

Futaba made 6-Channel FM 72Mhz/ R156F (6EXAP) Flight Transmitters System

QUALITIES:

Aileron, Elevator and Rudder twin rate switch - utilize this switch to ��flip�� between two aileron, elevator and rudder control throw settings. The tosses are setup however prefer, but in most cases, if the switch is ��up�� the throws are greater (��high rate��) when the switch is ��down�� the throws are less (��low rate��). This switch also flips between exponential rates (if used).
Flap control dial/Channel 6 - This dial runs the servo attached to channel 6 in receiver when your model has flaps this is actually the control used to use them.Aileron/elevator control stick -Mounting point for optional neck strap.
Trim levers (all) -Used to shift the neutral or center host to each servo as labeled into the diagram.
Billing jack - Port for asking you the transmitter batteries because of the included battery pack charger.
On-off switch
DATA INPUT lever - constantly replace the values with this different functions presented on LCD display screen.
Liquid-crystal display (LCD) - shows development modes and values joined up with.
MODE key - accustomed scroll through and show the ten or eleven(PCM) different functions.
CHOOSE key - accustomed show the values the current function.
Throttle-cut switch - to work with the throttle-cut function, paid down the throttle stick completely, then drive the throttle-cut change to completely shut the carburetor and shut linked to the motor.
Throttle/rudder control stick - runs the servos connected to channel 3 (throttle) and channel 4 (rudder) in the receiver.
Trainer switch - runs the trainer functions. To function as a trainer switch the transmitter should really be connected to another transmitter via. a trainer cable (available individually).
Retractable landing gear switch/Channel 5 - change operates the servo attached to channel 5 inside receiver as soon as your model has retractable landing gear this is actually the control constantly extend and retract the gear.
Antenna - Radiates signals towards receiver. Never ever travel a model without fully expanding the antenna or you may produce disturbance along with other modelers and decrease operational sign collection of the transmitter. The antenna are eliminated and replaced with another in the event its unintentionally broken.

Hot Brands

6EXAP 6-Channel FM 72Mhz/ R156F Futaba [6EXAP_c13]