Futaba FUAS3206 S3003 Servo Gear Upgrade Kit with Metal Gears - EBS3206 AS3206  [FUAS3206]

FUTABA S3003 SERVO GEAR SET EBS3206 AS3206
Price:
AUD$5.33
Brand:
Futaba
Model:
FUAS3206
GTIN:
4513886301285
Condition:
Brand New
Write a review

Repair and upgrade for S3003 servos

This kit supplies metal internal gears as a direct replacement for worn components inside Futaba S3003 servos. It is intended for scale RC service and lets users rebuild the gear stack to address slipping, stripped teeth, or excessive play without buying a new servo.

Installation notes: open the S3003 case using the standard disassembly procedure, remove the worn gears and replace them with the new parts keeping the original orientation and order. Verify correct gear mesh and endplay and ensure there is no binding before reassembling the case.

Tuning impact: upgraded metal gears can tighten response and reduce variability in endpoint repeatability. After fitting, set the servo to neutral and perform a bench run through the full travel to confirm smooth operation before refitting into the model.

How difficult is it to install these gears myself?

Installation is straightforward for anyone comfortable with small electronics; keep a clean workspace and note the order of gears and any shims. If unsure, photograph the stack before removal to aid reassembly.

Do the new gears require any special alignment or shims?

Fit the gears in the original positions and check axial clearance and mesh. Most installs use the factory shims; only add or remove shims if you detect improper mesh or binding.

What bench tests should I run after swapping the gears?

Power the servo and cycle it through full travel while watching for smooth movement, listening for unusual noise, and confirming the horn centers correctly. Address any binding before reinstalling the servo.

Copyright © 2008-2026 rcjaz.com.au All rights reserved