Futaba FUEBS3373 Direct-Fit Servo Case for BLS154 BLS174HV BLS174SV  [FUEBS3373]

FUTABA BLS154 BLS174HV BLS174SV SERVO CASE SET EBS3373
Price:
AUD$7.86
Brand:
Futaba
Model:
FUEBS3373
Condition:
Brand New
Write a review

What the case set does

This Futaba FUEBS3373 servo case set supplies a direct-fit replacement housing made to accept the internal components of Futaba BLS154, BLS174HV and BLS174SV servos. The case keeps the original mounting points so the servo refits cleanly into hobby models.

Designed as a service part, the shell is useful for repair work and bench diagnostics, allowing you to replace a damaged enclosure or test internal assemblies without disposing of the entire servo. It is for model use only and not intended for any real-vehicle application.

Installation notes: careful transfer of gears and electronics into the replacement shell is required. Verify gear engagement and horn orientation prior to tightening screws, and confirm travel and neutral on the bench to prevent binding or mis-centre issues.

What is the safest way to move the internals into the new case?

Remove screws carefully, support delicate gears and the PCB, note wire routing, and transfer parts one at a time to avoid losing small pieces.

Will using this shell extend the servo's lifespan?

Replacing a cracked or stressed housing prevents further external damage, but it does not change the internal wear characteristics. Proper assembly reduces the risk of premature failure.

Are special tools required to fit this case?

Basic watchmaker-style screwdrivers, fine tweezers and a bench power source for testing are usually sufficient. A small amount of appropriate grease for gears can help before reassembly.

Copyright © 2008-2026 rcjaz.com.au All rights reserved