Futaba S9153 Race-Grade Digital Control Servo  [S9153]

Futaba S9153 Digital Aileron/Elev High Speed/Torque BB
Price:
AUD$196.86
Brand:
Futaba
Model:
S9153
Condition:
Brand New
Write a review

Futaba S9153 Digital Servo Built for Precision and Power

The Futaba S9153 Digital Aileron/Elevator Servo pairs robust torque with rapid response to support precise control in performance RC models. It is suited to pilots who run demanding control surfaces under load.

Robust Materials and Heat Dissipation

Equipped with a coreless motor to reduce cogging and improve responsiveness, the S9153's metal center casing aids heat transfer and is sealed against water and dust. The unit comes with reinforced wiring to handle higher current without degradation.

Compatibility Tips and Installation Advice

The servo is supplied with a pre-installed "J" connector for quick connection. Note the S9153 is not compatible with some AM radios, including the CONQUEST AM and FG Series. Keep lead runs short, avoid Y-leads, and consider heavier wires for installations with high current draw.

Specifications

  • Speed: 0.15 sec/60 degrees @ 6V
  • Torque: 208 oz/in @ 6V (15 kg/cm)
  • Weight: 3 oz (85g)
  • Dimensions: 1.91" (48.6mm) x 0.99" (25.2mm) x 1.56" (39.7mm)
  • Mounting: 2.54" (64.6mm) including tabs, 0.55" (14mm) between same side holes, 2.35" (59.6mm) between opposite side holes

For flyers needing a dependable mix of speed and holding strength, the Futaba S9153 Digital Servo is a trustworthy option for high-demand control surfaces.

What power source is recommended for the S9153?

Use a stable 6V supply for rated speed and torque. If using a receiver BEC, ensure it can supply sufficient current or use a dedicated high-current BEC for demanding setups.

Will this servo fit standard 1/4 inch mounts?

Mounting dimensions are standard for many servos. Check the listed measurements against your mount points to confirm fit before installation.

Can I use the S9153 for both aileron and elevator duties?

Yes, this servo is specified for aileron and elevator use and provides suitable speed and torque for both, as long as control throws and linkage ratios are set appropriately.

How do I avoid interference with older AM gear?

Because the S9153 is not compatible with certain AM systems like CONQUEST AM and FG Series, verify your transmitter type before purchase and use compatible modern radios to avoid issues.

Copyright © 2008-2025 rcjaz.com.au All rights reserved