GF01/TL01 38mm Front and Rear CVD Shafts Aluminium-Steel Construction - GF1238C by GPM  [GF1238C]

Durable CVD half-shafts for GF01/TL01 builds

This aftermarket CVD shaft set is offered for Tamiya GF01 platforms and TL01 conversion projects. The pair is intended for front and rear use where a 38mm centre-to-centre half-shaft is required, replacing hollow or plastic shafts with a metal alternative.

The design combines aluminium mounting features with hardened steel driving surfaces to boost driveline durability without affecting suspension geometry. Fitment normally requires basic disassembly of hub carriers and the half-shaft retention hardware typical of GF01 and TL01 service procedures.

Before finishing assembly, verify stroke, outboard cup clearance, and confirm there is no interference with hexes or pins. Use a thread locker on mating fasteners where appropriate and validate free movement through the full suspension travel.

Choose this set for routine maintenance or when you want metal front and rear CVD shafts to replace ageing plastic parts while keeping the vehicle within the intended 1/10 scale drivetrain layout.