This cover plate is a direct-fit accessory for RC O.S. Engine GGT10 installations, functioning as a crank case seal and mounting interface. The entry outlines compatibility checks, preparatory installation steps, and how the part affects servicing and tuning.
Compatibility: Manufactured to suit GGT10-series cases, the plate corresponds to the case profile and factory mounting points for that engine family. Always confirm bolt pattern and surface condition before attempting to fit the component to ensure a reliable seal.
Installation notes: Remove the engine from the model, or secure it in a vise with soft jaws, then clean mating surfaces and strip away old gasket residues. Apply the manufacturer's recommended torque figures for case bolts, tighten in a cross pattern in stages to avoid bending, and check for thread damage before final tightening.
Tuning and service role: Even though compact, the cover plate supports case stiffness and alignment of internals, which can influence compression and crankshaft behavior. Inspect the part during routine service for any wear or damage that could result in leaks or alignment problems.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
