GGT10 Tuning Cylinder Head OS4A404000 for O.S. Engine  [OS4A404000]

O.S. ENGINES CYLINDER HEAD GGT10
Price:
AUD$20.19
Brand:
O.S. Engine
Model:
OS4A404000
GTIN:
4531028156845
Condition:
Brand New
Write a review

Tuning and rebuild uses for the GGT10 head

The O.S. Engine OS4A404000 cylinder head is an RC-scale replacement part for the GGT10 family. It closes the engine combustion chamber and is intended as a service component for compatible GGT10 engines from O.S. Engine during rebuilds and tuning work.

Installers should follow the engine manufacturer's removal procedure, inspect the head gasket and sealing faces, then reassemble the head using the correct bolt sequence and torque figures from the manual. Take care not to overtighten and verify clearance for the glow plug and cooling channels.

For tuning, a fresh head helps restore stable compression which can affect carburetor setup and overall engine response. Use this head when checking piston, sleeve, and carburetor settings to help achieve reliable performance.

Will changing the head alter compression and carburetor settings?

Replacing a worn or damaged head can restore compression consistency, which may require a subsequent check and fine tune of carburetor needle settings.

Should I recheck jetting after fitting this head?

Yes. After installing the head, verify idle and main needle settings as restored compression can change mixture needs.

Is a new head gasket required with this part?

A fresh head gasket is recommended to ensure a proper seal; do not reuse an old gasket when installing the replacement head.

Copyright © 2008-2026 rcjaz.com.au All rights reserved