GMADE R1 Two-Piece Main Drive Shafts Front & Rear - GM237SAAM by GPM  [GM237SAAM]

GMADE R1 ROCK BUGGY Steel+Aluminium Front + Rear Main Drive Shaft (F:122mm-132mm, R:105mm-115mm) - 2pcs set (Custom Colors) - GPM GM237SAAM
Price:
AUD$48.52
Brand:
GPM
Model:
GM237SAAM
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review
alt="GMADE R1 ROCK BUGGY Steel+Aluminium Front + Rear Main Drive Shaft (F:122mm-132mm, R:105mm-115mm) - 2pcs set (Custom Colors) - GPM GM237SAAM" title="GMADE R1 ROCK BUGGY Steel+Aluminium Front + Rear Main Drive Shaft (F:122mm-132mm, R:105mm-115mm) - 2pcs set (Custom Colors) - GPM GM237SAAM"

Front and Rear Drive Shaft Assembly

This two-piece main drive shaft set is built for the GMADE R1 Rock Buggy and carries model GM237SAAM. Steel is used where load and wear are highest while aluminium is used at the interfaces to help reduce rotating mass, and the supply includes both front and rear shafts in a 2pcs set.

Adjustable length ranges let you tune axle spacing: front 122mm to 132mm and rear 105mm to 115mm. Those ranges let you match axle and gearbox offsets on R1 chassis variants when swapping out stock parts or upgrading to metal components.

Confirm hub bore size and coupling method before fitting as these shafts mate to wheel hubs and transmission outputs. Fitting usually involves axle carrier removal and reassembly with compatible hex hardware; check spline engagement and bearing clearance after initial test runs.

Specifications

  • Item: Front + Rear Main Drive Shaft set
  • Material: Steel + Aluminium
  • Model Number: GM237SAAM
  • Compatibility: GMADE R1 ROCK BUGGY
  • Front Length Range: F:122mm-132mm
  • Rear Length Range: R:105mm-115mm
  • Quantity: 2pcs
  • Color: Custom Colors

Use this set to replace worn shafts or to firm up drivetrain response on a GMADE R1; always set lengths and coupling details to preserve correct axle geometry.

Do these require special tools to fit?

No specialised tools are required beyond standard hex drivers and basic workshop equipment for axle carrier removal and reassembly.

Can I replace only the front or rear shaft?

Yes, the set includes two shafts so you can replace one side as needed, but ensure the chosen length setting matches the axle geometry for that end.

Are colours consistent between batches?

The listing notes custom colours, which may vary by batch or supplier, so check the product images or seller notes for the current finish.

What maintenance is recommended?

Inspect splines and bearing seats after initial runs and periodically thereafter; keep mating surfaces clean and re-torque fasteners after break-in.

Copyright © 2008-2026 rcjaz.com.au All rights reserved