Governor Sensor Stay compatible with Eagle Freya EX-EP - HI0307022 by Hirobo  [HI0307022]

Mounting bracket for governor sensor on Eagle Freya EX-EP

This RC-scale governor sensor stay is supplied as a replacement mounting bracket for the Eagle Freya EX-EP range, intended to secure the governor sensor assembly on small helicopters. It creates a fixed point that keeps the sensor aligned to drivetrain and rotor assemblies, supporting consistent feedback during tuning and checks.

Fitment is straightforward for those used to helicopter maintenance: align the sensor with the original mounting pattern, ensure the bracket sits flush with the frame, and tighten the original hardware to secure it. After installation carry out a ground check to confirm sensor output and ensure no mechanical contact occurs with moving parts.

By holding the sensor steady under vibration and load, the stay supports repeatable governor performance when fine-tuning RPM or gain. Remember this is a service replacement accessory and verify your Eagle Freya EX-EP variant's compatibility before ordering.