HD Drive Spacer for Tomahawk 85 WC, compatible with Scorpion Series - Kyosho SCW034  [KY-SCW034]

Kyosho SCW034 - HD Drive Washer (2pcs/85WC Tomahawk)
Price:
AUD$17.96
Brand:
Kyosho
Model:
KY-SCW034
GTIN:
4548565519743
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $15.08 each $5.75 or 16%
3+ $14.33 each $10.89 or 20%
Write a review

Sturdy HD Washer for RC Drivetrains

The Kyosho SCW034 HD drive washer is an aftermarket-style spare intended to maintain correct lateral clearance on the Tomahawk 85 WC and on Scorpion Series gear layouts that accept the same washer form. Two pcs are supplied so you can match both sides of a drive assembly or keep one as a service spare.

Built as a heavy-duty spacer, it holds hub and gear faces in the intended positions without changing gear mesh. It is useful when a thin, consistent shim is required to remove binding or to dial in drivetrain alignment on 1/8 and similar scale rigs sharing the Tomahawk/Scorpion setup.

Fitting is quick: take off the hub or gear stack, position the washer on the shaft where needed, spin the drivetrain through suspension travel to confirm free movement, and reassemble. Verify bearings are not forced out of their preload and keep spacing identical on both sides to maintain handling predictability.

Packing includes

  • HD drive washer - 2 pcs
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How does this washer help under heavy loads?

The HD profile is made to resist deformation and keep consistent spacing under load, reducing the risk of intermittent binding in high-torque sections of the drivetrain.

Do I need to change other spacers after fitting?

You may need to tweak adjacent shims to preserve correct gear mesh. Fit the washer, check engagement, and adjust nearby spacers if the mesh becomes too tight or too loose.

Is this suitable for track and off-road use?

Yes, the HD washer is designed for demanding conditions if the geometry matches. Always inspect for contamination or wear after rough runs and replace when necessary.

Can I mix this with different washer materials?

Mixing materials can change friction and compression characteristics. If you mix types, recheck clearances and bearing preload to ensure consistent performance.

Copyright © 2008-2026 rcjaz.com.au All rights reserved