Hirobo Shuttle Tail Alignment Clamp KS313 for setup - K&S  [KS313]

K&S TAIL SUPPORT CLAMP HOLDER FOR HIROBO SHUTTLE #313
Price:
AUD$10.71
Brand:
K&S
Model:
KS313
Condition:
Brand New
Write a review

Setup and alignment aid for tail work

This tail support clamp holder is designed for use with the Hirobo Shuttle model. It functions as a temporary support to lock the tail assembly in place while you make trim adjustments and tune control linkages.

The clamp-style holder prevents unwanted movement so you can adjust the tail boom, linkage geometry, and pitch without the airframe shifting. Fit the clamp onto the boom or mount point, ensure it does not restrict tail rotor movement, and tighten to secure the assembly without causing distortion.

Use the clamp as part of your setup routine for tail control and trimming tasks. Always check rotor clearance and full control travel before any powered operation. This product is intended for RC model use only.

Will using the clamp affect tail trim results?

Clamping the tail for adjustments provides a stable reference, which helps achieve consistent trim. Remove the clamp and recheck control responses in free conditions before flight.

Any tips for tuning linkages while the clamp is fitted?

Set linkages with the clamp holding the tail in the neutral position, then make small incremental changes and verify symmetry. Confirm movement range for pitch and yaw after adjustments.

Can the KS313 help with cyclic and tail coordination checks?

Yes. By stabilising the tail, the clamp lets you isolate and inspect tail inputs while checking coordination between tail and cyclic adjustments during setup.

Copyright © 2008-2026 rcjaz.com.au All rights reserved