Xrotor 20A 4IN1 Micro - 30901065 HOBBYWING  [HW-30901065]

Definitely Integrated

This XRotor 4IN1 Micro ESC not merely includes 4 superior 20A ESCs,
1 built-in BEC, but additionally output ports for powering peripherals like FC, digital camera,
and a port for FC checking present and voltage immediately. The highly built-in
framework makes the installation and wiring simple and easy clean.

Direction Reversal via TX

Rotation way of each motor are set via transmitter.
This saves the problem of re-soldering/re-connecting after connected/soldered engines to
the ESC freely and discovered engine runs backwards.

Quality Components

The using high end 32-bit supply processors
(aided by the running regularity as high as 48MHz),
integrated drive ICs, imported quality MOSFETs,
3-ounce copper and 6 levels of PCBs guarantees less temperature,
higher effectiveness and rapider effect.

Oneshot125, Oneshot42 & Multishot Modes set!

This Xrotor 20A 4IN1 Micro ESC not only supports
regular throttle signals (using the regularity all the way to 621Hz),
Oneshot125 (125-250μs) high-speed throttle signals
(with the real-time frequency as high as 3.8KHz),
and Oneshot42 (42-81μs) and Multishot (2-25μs) super
high rate throttle signals. This makes interaction
between FC and ESC more agile, throttle linearity smoother,
and throttle response rapider.

DEO Technology/Active Freewheeling

The DEO (Driving effectiveness Optimization) technology
applied inside ESC has numerous benefits:
● Active braking. Whenever reducing the throttle amount, the engine will
decelerate rapidly. This kind of function permits pilots to more easily
perform all maneuvers like razor-sharp turns, altitude changes,
and sudden braking.
● Higher driving effectiveness, longer journey time.
● Lower ESC heat and an even more dependable operation.

Engine Lock-up Protection

This XRotor 20A 4IN1 Micro ESC lessens its manufacturing to engine immediately
with regards to detects the engine shaft is locked up.

Splash-proof

The entire circuit board and all kinds of the elements on
it have gone through nano-coating therapy;
this may result in the XRotor 20A 4in1 Micro ESC splash-proof.

Specifications

• Cont./Peak Current : 20A×4/25A×4
• LiPo Cells : 3-4S LiPo
• BEC manufacturing : 5.3V/12V，3A

Wires & Connectors

• Output Wires : No cables but solder tabs
• Input Connectors : No
• Output Connectors : No
• Firmware : HW Special Program for FPVs
• ESC Programming : Supported
• Stick Programming : Transmitter
• DEO : Supported
• Throttle Range Calibration : Supported
• Oneshot125 Mode : Supported
• Oneshot42 Mode : Supported
• MultiShot Mode : Supported
• Timing : perhaps not Supported
• Motor Rotation : Supported

Size & Weight

• Size : 54x36x7mm
• Weight : 24.5g

Applications

• 130-280mm FPVs