HOBBYWING XRotor Micro 20A BLHeli ESC - 30901066 Micro FPV Controller  [HW-30901066]

HOBBYWING XRotor micro 20A BLHeli - 30901066
Price:
AUD$22.72
Brand:
Hobbywing
Model:
HW-30901066
Condition:
Brand New
Write a review
alt="HOBBYWING XRotor micro 20A BLHeli - 30901066" title="HOBBYWING XRotor micro 20A BLHeli - 30901066"
alt="HOBBYWING XRotor micro 20A BLHeli - 30901066" title="HOBBYWING XRotor micro 20A BLHeli - 30901066"
alt="HOBBYWING XRotor micro 20A BLHeli - 30901066" title="HOBBYWING XRotor micro 20A BLHeli - 30901066"
alt="HOBBYWING XRotor micro 20A BLHeli - 30901066" title="HOBBYWING XRotor micro 20A BLHeli - 30901066"

Compact ESC engineered for lightweight FPV rigs

The Hobbywing XRotor micro 20A BLHeli ESC is tailored for pilots building small, agile drones where compact electronics are essential. It sits comfortably in 130-280mm frame layouts and helps keep overall weight down.

High quality internals for efficient running

Equipped with an F396 48MHz MCU and imported MOSFETs, this ESC aims to reduce heat and maintain efficiency. Ceramic capacitors plus a 3-in-1 drive IC boost reliability during extended or aggressive flights.

BLHeli support and group programming

Flash or update BLHeli firmware through the signal cable. When used with a CleanFlight flight controller the ESCs can be updated in groups of four, simplifying tuning and calibration.

Improved braking and rapid throttle feedback

Support for Damped Light delivers better motor braking, while OneShot125 gives higher speed throttle communication for snappier control response.

Signal lead design to lower interference

The twisted-pair throttle signal cable reduces electrical noise on the control line, improving signal clarity and flight stability in ordinary flying conditions.

Specifications

  • Continuous/Peak Current: 20A/30A
  • LiPo Cells: 2-4S LiPo
  • BEC Output: No
  • Throttle Range Calibration: Supported
  • Size: 24.0x13.9x5.5mm
  • Weight: 7g

A good match for 130-280mm diagonal frames, the Hobbywing XRotor micro 20A BLHeli ESC combines compact size with firmware flexibility and practical anti-interference wiring.

This 20A ESC pairs best with small to mid-sized motors and props typical of 130-280mm quads. Match motor Kv and prop size to your desired flight style for safe current draw.
Yes, when connected through a CleanFlight-capable FC the firmware can be flashed to four ESCs at once using the signal cable, which saves time tuning multiple units.
This ESC does not include a BEC output, so use a flight controller with a regulator or an external BEC to supply receivers and other electronics.
Keep signal leads away from high-current motor and battery wires, twist your signal pairs where possible, and use the supplied twisted-pair lead to reduce noise pickup.

Copyright © 2008-2025 rcjaz.com.au All rights reserved