HPI Baja Front Rim Frame Nylon Carrier Alloy 10-Pole Design BJ1003F by GPM  [BJ1003F]

HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F
Price:
AUD$108.58
Brand:
GPM
Model:
BJ1003F
GTIN:
4894538025002
Condition:
Brand New
Write a review
alt="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F" title="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F"
alt="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F" title="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F"
alt="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F" title="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F"

Replacement front rim for HPI Baja buggies

This front rim frame is produced for HPI Baja scale vehicles and carries model number BJ1003F. It uses a molded nylon carrier to provide structural support while an alloy ten-pole patterned face adds localized stiffness and an off-road ready appearance.

As a replacement or upgrade item, the design emphasises secure wheel mounting and consistent behaviour when running off-road. It is compatible with standard Baja hubs and wheel hardware in most setups, but always verify hex size and offsets before installation.

Installation follows common wheel service steps: remove the tyre and wheel, place the rim frame onto the hub location, and fasten using your original wheel screws. The nylon carrier offers some flex to absorb impacts and the alloy face will alter mass distribution slightly compared with fully plastic rims.

Specifications

  • Item: Front Rims Frame
  • Material: Nylon and Alloy
  • Model Number: BJ1003F
  • Compatibility: HPI Baja

Use BJ1003F for front rim replacements or when you want the combined feel of a flexible nylon carrier and an alloy-pattern rim face on your HPI Baja.

Do I need special parts to fit this?

No special parts are usually required; the rim frame fits onto standard Baja hubs but confirm that the hex and wheel offset match your setup.

Will tyres mount the same as before?

Yes, tyres mount in the same way provided the rim frame is properly seated and secured with the original wheel hardware.

Is the alloy face structural?

The alloy face adds local stiffness to the wheel face but the primary structural element is the nylon carrier; the combo aims to balance durability and impact absorption.

Any tips for track use?

Check wheel balance after fitting if you race at high speed, and inspect mounting points regularly when running on rocky or rooty tracks.

Copyright © 2008-2026 rcjaz.com.au All rights reserved