HPI Bullet 3.0 Front C Hub Carrier Upgrade Orange Alloy - BUL-18001-OR by Jazrider  [BUL-18001-OR]

Front C hub carrier — compatibility and benefits

An orange anodized alloy front C hub carrier made for HPI Bullet platforms, supplied as an aftermarket upgrade for BULLET 3.0 MT and ST models. It couples the steering knuckle to the upright on the vehicle's front suspension, suitable for nitro-powered builds.

Finish and durability: anodized alloy construction helps resist abrasion at hinge-pin and ball-stud contact zones while maintaining a consistent bearing face for steering linkages. This firmer substrate can cut down on the flex that sometimes occurs with stock plastic hubs.

Fitment details: engineered to match the front suspension geometry found on Bullet 3.0 MT and ST variants. Where the original HPI mounting layout is used, the carrier takes the same hinge pins, ball studs and linkage alignments as the OEM part for straightforward swapping.

Installation tips: remove the standard C hub, move bearings, wheel hexes and steering hardware to the alloy carrier, then check steering travel and wheel toe. Confirm there is no binding during suspension articulation. A more rigid carrier can help make steering behavior and setup adjustments more consistent.

Contents and packaging may vary by merchant; check the seller listing to confirm included parts.