HPI Bullet 3.0 Front/Rear CVD Shaft Steel #45 SBMT283 by GPM  [SBMT283]

Steel CVD swing shaft tuned for HPI Bullet 3.0

The SBMT283 front/rear CVD swing shaft is a steel replacement part intended for HPI Bullet 3.0 MT and ST chassis. Constructed from steel #45, it offers higher wear resistance than typical stock shafts and helps control flex under demanding off-road loads.

The component installs into the CVD locations on compatible HPI Bullet 3.0 MT and ST models; confirm retaining clips and clearances before finishing assembly. Moving to a steel #45 shaft will stiffen the driveline and change the feedback drivers feel, so adapt differential and throttle settings as needed.

Use the GPM SBMT283 when you want a robust, direct-fit steel solution for front and rear CVD positions on HPI Bullet 3.0 MT and ST, and account for its influence on driveline feel when setting up the vehicle.