HPI Bullet 3.0 MT/ST 7pc Tie Rod Set Spring Steel BMT160ST by GPM  [BMT160ST]

Direct-fit tie rods for HPI Bullet 3.0 MT and ST

This replacement tie rod kit is produced as a direct aftermarket option for HPI Bullet 3.0 MT and ST nitro chassis, covering fundamental steering and suspension link duties. Spring steel bars with plastic end fittings deliver thread adjustability and pivot security while keeping mass low.

The seven-piece kit replaces worn steering and suspension links to recover original handling and toe settings without modifying chassis geometry. Parts are supplied as aftermarket equivalents intended for scale RC use.

Fitting notes: inspect ball cups and threaded parts for wear and replace degraded components before assembly. Adjust rod lengths to match the original setup and verify that steering and suspension articulate freely to prevent binding.

Fit this set to restore worn linkages and consistent steering feedback; always check alignment and run the suspension through its travel after installation.