HPI Bullet 3.0 MT/ST Blue Graphite Radio Tray GBMT014B by GPM  [GBMT014B]

Blue graphite radio tray for Bullet 3.0 MT/ST

This graphite radio tray is an RC replacement specifically made for HPI Bullet 3.0 MT and ST models that run Nitro engines. It provides a dedicated mounting surface for the receiver, servo and small electronic components while keeping wiring routed neatly inside the standard chassis layout.

The tray is graphite with a blue finish and is intended to sit in the radio bay following the original Bullet 3.0 MT and ST mounting pattern. The design emphasises a rigid, low-profile plate that lines up with common 1/10 off-road component positions without adding bulk.

Fitting advice: the tray is supplied as a single piece and should be installed using existing chassis screw positions where compatible. Route antenna and power leads along the model stock paths and verify servo and fuel tank clearances on Nitro Bullet 3.0 MT/ST variants before final tightening.

Usage note: use this tray to maintain consistent radio placement during setup and to simplify receiver or servo swaps during maintenance, preserving the primary chassis geometry.