This graphite radio tray is an RC-scale replacement designed for HPI Bullet 3.0 MT and ST nitro models, supplied as 1pc. It provides the mounting surface for the receiver and main servos, locating electronics within the chassis and protecting wiring runs.
Positioned to replace the stock radio tray area on Bullet 3.0 MT/ST nitro chassis, the graphite construction increases rigidity over plastic options and helps resist flex that can blur steering input. The tray is intended to be fitted using the vehicle's existing mounting points and hardware to maintain the factory layout.
During setup, consider how tray placement and servo arrangement affect the centre of gravity and cable routing; a stiffer tray can make servo feedback more consistent but verify clearance with fuel lines and the exhaust on nitro setups.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
