HPI Bullet FLUX Steering Linkage Kit - Orange Alloy BUL-18002-OR by Jazrider  [BUL-18002-OR]

Bullet FLUX Alloy Steering Upgrade

This orange alloy steering assembly is designed for the HPI Bullet FLUX platform and replaces the original plastic steering components. Bearings are included to minimise slop and provide a more direct steering feel. The item is intended as a chassis hop-up to enhance steering control rather than change motor or drivetrain characteristics.

Fitting guide

• Check the Bullet FLUX MT or ST linkage and remove the stock knuckles, then mount the alloy assembly into the same points on the chassis.
• Re-use compatible mounting hardware when feasible and verify there is adequate clearance with your servo horn and tie-rods before tightening.
• After fitting, set the steering to centre and confirm toe and travel settings to ensure consistent steering inputs.

Tuning impact

• Using alloy knuckles with bearings reduces pivot slop, delivering repeatable steering response beneficial for setup adjustments and high-precision testing.
• Adjust servo rates and linkage geometry in conjunction with this upgrade to tune steering speed versus stability.