HPI Bullet Front and Rear Shock Tower Upgrade - BUL-18005-GU by Jazrider  [BUL-18005-GU]

Stiffer mounting for better cornering

This RC-scale alloy front/rear shock tower set is made for HPI Bullet chassis and comes as 1 pcs in a gunmetal coating. The single-piece tower unites body mount points and gives a firmer mounting surface for shocks and body posts compared to factory plastic towers.

In use the item increases rigidity around the suspension mounts and helps keep body mounts steady during high-load events. For tuning it modifies how the suspension transmits forces through the tower, aiding in maintaining shock alignment under load.

Installation is aimed at experienced builders: the piece replaces the stock towers at both front and rear using the original chassis mounting locations, and usually accepts the same screws and posts. During installation hand-start hardware and check shock shaft and body post alignment prior to final torque to prevent binding. No extra hardware is included unless the retailer notes otherwise.