HPI Bullet Front Chassis Stiffener (gunmetal) for Bullet 3.0 MT/ST - BUL-18004-GU by Jazrider  [BUL-18004-GU]

HPI Bullet - Gunmetal Alloy Front Chassis Brace
Price:
AUD$14.96
Brand:
JAZRIDER
Model:
BUL-18004-GU
Condition:
Brand New
Write a review

Tuning-oriented front chassis brace

This RC-scale front chassis brace fits the HPI Bullet lineup and carries model designation BUL-18004-GU from JAZRIDER. The gunmetal alloy brace is intended to add targeted stiffness at the front of the chassis, enabling finer adjustments to handling and balance during setup work.

The part secures to the existing front chassis mounts and is designed to work with the Bullet 3.0 MT and ST nitro chassis without modifying fundamental geometry. Its tuning effect is specific: increase front stiffness to influence turn-in behavior and front grip characteristics when making setup changes.

Fitment notes: confirm mount alignment before fitting; this is a replacement/upgrade brace for the front section and should be treated as a tuning hop-up, not a full chassis swap.

How will this brace change handling at high speed?

Increasing front stiffness generally sharpens turn-in and reduces flex under load, which can improve response but may reduce compliance on rough surfaces. Adjust damping to suit.

Should I alter shock settings after fitting?

In many cases you will need to re-tune front springs and damping to balance the stiffer front end and preserve traction and handling balance.

Is this suitable for converted electric Bullets?

The brace is designed for the Bullet 3.0 MT/ST nitro layout. If your electric conversion retains the same front mount points and geometry it may fit, but verify alignment before purchase.

Copyright © 2008-2026 rcjaz.com.au All rights reserved