HPI Bullet Front C Hub Carrier Upgrade for BULLET 3.0 MT/ST - BUL-18001-BK by Jazrider  [BUL-18001-BK]

HPI Bullet - Black Alloy Front C Hub Carrier
Price:
AUD$14.63
Brand:
JAZRIDER
Model:
BUL-18001-BK
Condition:
Brand New
Write a review

C Hub Carrier: Key Notes

This front C hub carrier is an aftermarket component for HPI Bullet models noted as BULLET 3.0 MT and ST (Nitro Engines). It is described as a black alloy front C hub carrier that mounts the steering knuckle and connects the wheel hub to the chassis steering/suspension linkages.

From a tuning viewpoint the carrier establishes the hub center locations and steering pivot points, which affects toe, camber behavior under load, and bearing preload. When replacing, use the correct mounting hardware, confirm clearances, and refit using standard hex drivers and common hand tools.

How does this affect steering geometry?

The carrier sets the hub pivot and can change steering throw and response. Small differences in carrier location alter toe and camber behavior, so inspect geometry after fitment.

Any recommended torque or service notes?

Tighten fasteners to the vehicle manufacturer's recommendations where available. Check bearing preload and free rotation after assembly and recheck after a short run.

Will this change bearing preload?

Yes, carrier fit and spacer placement can change preload. Reassemble carefully and adjust spacers or shims to achieve correct bearing tension.

Copyright © 2008-2026 rcjaz.com.au All rights reserved