HPI Bullet Front Suspension Arm Upgrade for Bullet 3.0 MT/ST - Gunmetal - BUL-18003-GU by Jazrider  [BUL-18003-GU]

HPI Bullet - Gunmetal Alloy Front Suspension Arm Set
Price:
AUD$20.61
Brand:
JAZRIDER
Model:
BUL-18003-GU
Condition:
Brand New
Write a review

Performance-focused front arms for Bullet

These front suspension arms are an RC-scale replacement for HPI Bullet platforms, supplied as model BUL-18003-GU. The gunmetal alloy construction is intended to slot into the stock Bullet 3.0 MT and ST front suspension without changing factory geometry.

They are ideal when you want a direct-fit spare or a basic upgrade to reduce control loss from flex compared with stock plastic parts. Installation is straightforward: remove hub and pivot pins, swap arms, reinstall the vehicle hardware and verify free travel and full steering sweep. No specialist tools beyond common hex drivers are needed.

From a tuning standpoint the alloy arms help maintain alignment during hard landings and high-speed cornering on nitro off-road setups. They produce minimal change to ride height, so tune the dampers and toe/inset to refine handling rather than altering the arms.

How will these arms affect vehicle tuning?

Expect reduced flex which keeps alignment more consistent; handling tweaks should therefore focus on shocks and steering geometry to capitalise on the stiffer arms.

Do I need to change shock settings after fitting?

Minor shock adjustments can help compensate for the stiffer control arms, but start with small increments to damping and spring rates and test progressively.

Is additional servo or steering modification required?

No changes to steering components are normally necessary; verify steering range and trim after installation and only adjust linkage if binding occurs.

Copyright © 2008-2026 rcjaz.com.au All rights reserved