JAZRIDER BUL-18000-GU Front Knuckles Gunmetal Alloy for HPI Bullet  [BUL-18000-GU]

HPI Bullet - Gunmetal Alloy Front Knuckle Arms
Price:
AUD$16.15
Brand:
JAZRIDER
Model:
BUL-18000-GU
Condition:
Brand New
Write a review

Rugged Knuckles for HPI Bullet

The JAZRIDER BUL-18000-GU gunmetal alloy front knuckle arms are a straightforward upgrade for HPI Bullet owners after stronger steering components. They are designed to resist bend and wear during off road use and spirited driving.

Material Benefits

Gunmetal alloy construction reduces flex compared to plastic arms and helps maintain steering geometry under impact. The result is steadier handling and fewer mid-run adjustments.

Fitment and Installation

These knuckles are made to pair with HPI Bullet 3.0 MT and ST hubs and steering assemblies. Installation is simple for anyone familiar with routine RC maintenance and uses standard fasteners.

Will these knuckles add weight to the front end?

They are heavier than plastic, which can slightly alter front-end balance, but the tradeoff is reduced flex and improved steering precision.

Are spacers or shims needed after installation?

Most installs do not need shims. After fitting, check tie rod clearance and wheel toe, and adjust as required for correct geometry.

Do these knuckles require different balllinks?

They use the same balllink locations as the original parts. Confirm fitment with your steering setup and replace any worn hardware during the upgrade.

Copyright © 2008-2025 rcjaz.com.au All rights reserved