HPI Bullet Rear Chassis Brace Upgrade for Bullet 3.0 MT/ST - Gunmetal Alloy BUL-18008-GU by Jazrider  [BUL-18008-GU]

HPI Bullet - Gunmetal Alloy Rear Chassis Brace
Price:
AUD$16.62
Brand:
JAZRIDER
Model:
BUL-18008-GU
Condition:
Brand New
Write a review

Tuning brace for improved rear response

This rear chassis brace is an RC-scale replacement part made for HPI Bullet platforms and produced by JAZRIDER under model BUL-18008-GU. The gunmetal alloy rear brace is intended to stiffen the rear chassis on Bullet 3.0 MT and ST nitro variants to influence handling behavior.

As a tuning item the brace deliberately increases rear stiffness, which alters how the car delivers power and how rear traction behaves over rough ground. It installs at the stock rear mounting points and serves as a structural modification rather than an electronic enhancement.

Installation tips: check for alignment with rear bulkhead fasteners and ensure there is no contact with the exhaust or fuel tank. Use thread locker on metal fasteners if you prefer and test-drive to determine any necessary suspension or toe adjustments after fitting.

How does this brace change handling at speed?

By stiffening the rear chassis, the brace reduces flex during throttle transitions, which can make rear traction more immediate; expect different mid-corner balance and possible need for damping or toe tweaks.

Should I alter spring or shock settings after fitting?

Small adjustments to rear shock damping or spring rate may be beneficial to harmonize the stiffer chassis with suspension response and maintain predictable handling.

Is this suitable for both competition and bashing setups?

Yes. The brace suits both applications, but competition setups may require finer suspension tuning to extract the handling benefits from the increased rear stiffness.

Copyright © 2008-2026 rcjaz.com.au All rights reserved