HPI Bullet Rear Stiffening Brace for BULLET 3.0 - BUL-18008-BK by Jazrider  [BUL-18008-BK]

HPI Bullet - Black Alloy Rear Chassis Brace
Price:
AUD$16.62
Brand:
JAZRIDER
Model:
BUL-18008-BK
Condition:
Brand New
Write a review

Rear stiffening brace designed for BULLET 3.0

This alloy rear chassis brace is a scale replacement part made to fit HPI Bullet platforms. It acts as a direct reinforcement at the rear section to cut down chassis flex during aggressive driving and on heavy jumps.

Black alloy construction provides a firmer mount for rear suspension parts and connected components. It lists compatibility with BULLET 3.0 MT and ST variants of the HPI Bullet range, so confirm your specific model before purchase.

Fitting is straightforward for anyone experienced with hop-up parts, using the factory rear mounting points and existing hardware holes. Common tools include the correct hex driver for your fasteners and general hand tools; adjust rear suspension settings after fitting to fine tune handling.

Will this brace affect jump landings?

Yes. By increasing rear-end stiffness the brace can change how the vehicle behaves on landings; expect firmer recovery and altered pitch response. Test gradually to dial in the balance.

Does the part require new fasteners?

The brace mounts to existing factory holes and usually uses the vehicle's stock fasteners. Inspect your hardware during installation and replace worn screws as needed for a secure fit.

How should I evaluate handling changes?

Treat the brace as a single setup change: fit it, then run controlled tests comparing traction and stability before altering other settings. Note differences in cornering and mid-air attitude.

Copyright © 2008-2026 rcjaz.com.au All rights reserved