HPI Bullet Rear Suspension Arm Upgrade - Orange Alloy - BUL-18010-OR by Jazrider  [BUL-18010-OR]

HPI Bullet - Orange Alloy Rear Suspension Arm
Price:
AUD$20.61
Brand:
JAZRIDER
Model:
BUL-18010-OR
Condition:
Brand New
Available in shop
Write a review

Replacement Arm Description

This orange alloy rear suspension arm serves as an RC-scale replacement for HPI Bullet vehicles. It is intended to swap in for damaged stock arms or as a stronger alloy alternative for routine use and track sessions.

The item is compatible with Bullet 3.0 MT and ST (Nitro Engines) per the product notes; always verify the arm aligns with your existing mounts before tightening hardware. Typical fitting steps include removing the rear wheel, disassembling the rear hub and linkage, and reattaching using the original fasteners.

In tuning scenarios the arm acts as a fixed component that maintains factory suspension geometry, allowing you to preserve handling characteristics after repairs. Use appropriate RC tools and observe safety practices when servicing fuel-powered chassis.

Will fitting this arm change rear handling or ride height?

As a direct replacement it preserves the original suspension geometry, so ride height and basic handling should remain unchanged unless combined with other adjustable parts.

Can this arm be used with adjustable link kits?

The arm itself is fixed; it can work alongside adjustable links, but you should verify clearances and mounting locations when mixing components.

Any recommended checks after installation?

After fitting, confirm free suspension travel, check for binding at pivots, and torque fasteners to the vehicle manufacturer recommendations.

Copyright © 2008-2026 rcjaz.com.au All rights reserved