The SSAV12110 is a steel universal swing shaft made for front and rear use on the HPI Savage 21 platform. It uses the wide 5mm specification and ships as a one-pair set complete with adaptor, pins and washers for fitting.
Use this shaft to replace stock components where the wider 5mm configuration is called for. The part is intended to restore correct driveline coupling and to support routine servicing or modest tuning focused on reliability rather than outright performance gains.
Installation overview: insert the shaft into the vehicle hubs and suspension assemblies and secure with the supplied adaptor, pins and washers. Verify hub geometry and correct pin alignment while tightening; if you are running upgraded hubs or nonstandard hexes, confirm fit before final torque.
Recommended when replacing worn swing shafts or matching a 5mm wide driveline in HPI Savage 21 projects; always check alignment and pin security after installation.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
