HPI Savage 21 Wide 5mm Universal Swing Shaft TSAV12110 Titanium by GPM  [TSAV12110]

HPI Savage 21 Titanium Front/Rear Universal Swing Shaft (Wide 5mm With Drive Adaptor & Pins & Washers) - 1pr set - GPM TSAV12110
Price:
AUD$64.23
Brand:
GPM
Model:
TSAV12110
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Titanium universal swing shafts for HPI Savage 21

This kit supplies a pair of titanium universal swing shafts for the HPI Savage 21, intended as an aftermarket upgrade. The set ships with the wide 5mm drive adaptor plus pins and washers to suit the specified interface for front and rear use.

The swing shafts are intended to drop into the existing differential and hub assemblies where the Savage 21 geometry matches. Installers should verify retainer fit and pin orientation, and run a final check for smooth rotation across steering and suspension travel.

Specifications

  • Item: HPI Savage 21 Titanium Front/Rear Universal Swing Shaft (Wide 5mm)
  • Material: Titanium
  • Model Number: TSAV12110
  • Compatibility: HPI Savage 21
  • Package Contents: 1pr set, drive adaptor, pins, washers

Fit this set when replacing damaged swing shafts or when converting to the wide 5mm adaptor layout; always confirm clearances before final tightening.

Titanium components resist wear better than some steels and can extend service life under typical RC use, though overall strength depends on the whole driveline setup.
Differentials normally remain the same; the shafts are designed to mate with standard Savage 21 diff and hub interfaces where compatible.
Keep joints clean, inspect pins and washers after each hard session, and replace any worn retainers to maintain secure engagement.
Light grease on the pin interfaces is sufficient; avoid excess that can attract grit into the joint.

Copyright © 2008-2026 rcjaz.com.au All rights reserved