HPI Savage Compatible 32T Delrin Drive Gear DSAV1232T by GPM  [DSAV1232T]

HPI Savage /Savage Fluorescent x Delrin Drive Gear (32T) - 1pc (Sav) - GPM DSAV1232T
Price:
AUD$13.78
Brand:
GPM
Model:
DSAV1232T
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Replacement 32T drive gear for Savage

Single 32T Delrin drive gear for use with HPI Savage chassis, supplied as 1 pcs. The Delrin construction gives a low friction surface and quieter meshing compared with metal gears, while the fluorescent finish assists quick visual checks during setup and maintenance.

Installation guidance: loosen the spur/pinion mesh where necessary, remove the worn drive gear and fit this unit, then set mesh and endplay. Use the original retaining screws and verify the gear locates and spins freely on the diff output or gearbox shaft prior to use.

Tuning use: this Delrin gear is a practical choice for testing mesh configurations, lowering drivetrain noise and helping to protect metal mating gears. Replace when teeth show signs of rounding, cracking or excessive wear.

What should I check to confirm fitment?

Measure the diff output spline and shaft diameter and compare to your original gear; compatibility depends on matching those dimensions.

Will this reduce drivetrain noise?

Yes, Delrin typically cuts engagement noise compared with metal gears, making it useful for diagnostic runs and quieter operation.

How often should I inspect the gear?

Inspect the gear after the first few runs and then at regular maintenance intervals, replacing it if tooth edges appear rounded or material loss is noticeable.

Copyright © 2008-2026 rcjaz.com.au All rights reserved