This front/rear alloy C-Hub is intended for HPI Savage chassis and serves as the steering knuckle mount within the suspension layout. It is offered as an aftermarket upgrade to restore damaged C-Hubs or refresh worn steering linkages without claiming OEM origin.
Made from aluminium alloy, the hub accepts standard king pins and is shipped with the small hardware required to secure it to steering arms and axle mounts. Fitting alloy components can help maintain geometry under load and reduce play often seen in worn plastic parts.
Fitment tips: confirm king pin and e-clip seating, torque fasteners to a sensible level consistent with your chassis, and recheck wheel alignment and toe after installation. Avoid over-tightening pivot screws to prevent steering bind.
Fit this GPM alloy C-Hub to replace worn knuckles on supported Savage variants, perform alignment checks after fitting, and keep spare king pins and e-clips as part of your maintenance kit.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
