HUDY 293084 10g Chassis Balancing Weights (Set of 4)  [HSP-293084]

HUDY 293084 - Precision Balancing Chassis Weight 10g (4)
Price:
AUD$66.17
Brand:
HUDY
Model:
HSP-293084
Condition:
Brand New
Write a review

Precision Weighting with HUDY 293084

Get reliable, repeatable balance adjustments using the HUDY 293084 Precision Balancing Chassis Weights. This four pack of 10g steel pieces is made for tidy placement where you need incremental mass.

Secure Mounting and Identification

The weights are formed from tough steel and can be fastened into pre-drilled chassis mounting points or stuck down with double-sided tape for temporary tests. Laser-etched values make it easy to identify each piece during setup changes.

Practical Balancing Tips

Use a chassis balancer to detect lean and add these weights step by step until the chassis sits level. Stacking is supported for smaller incremental changes, giving you control over the final trim.

Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.
Yes. If there are mounting holes you can screw them in, otherwise use high-bond double-sided tape on a clean flat area.
Stacking increases local mass but keep stacks low to avoid raising the centre of gravity significantly. Small stacks are best for minute balancing.
Start with single 10g increments and test on a balancer and on-track. Fine tune from there rather than making large jumps in weight.
They change static weight distribution which can alter roll and ride height slightly, so revisit spring and damping settings after major balance changes.

Copyright © 2008-2025 rcjaz.com.au All rights reserved