IP-CC2S3800V3-35C by Intellect - 7.4V 3800mAh 35C Hard Case Li-Po (Pin Connectors)  [IP-CC2S3800V3-35C]

Intellect (IP-CC2S3800V3-35C) - 7.4V 35C 3800mah Lipo Battery
Price:
AUD$51.18
Brand:
Intellect
Model:
IP-CC2S3800V3-35C
Write a review

Installation notes and clearance

The Intellect IP-CC2S3800V3-35C is a hard-case 2S Li-Po race pack offering 7.4V and 3800mAh capacity for 1/10 electric on-road cars. It uses 35C lithium polymer cells and arrives with 4mm discharge pins and a 2mm balance pin, suited to race chargers and ESC inputs that accept those connectors.

When fitting the pack, confirm tray dimensions and lead routing to prevent interference with servos or driveline parts. The hard case helps prevent movement under standard tie-downs, but ensure the pack sits flat and the balance lead does not rub on moving components. For replacements, align voltage and capacity to your ESC and motor tuning plan rather than simply matching outer size.

On the track, capacity and discharge rate influence run length and voltage behaviour under load: 3800mAh gives a useful compromise of endurance and mass for short races, while 35C yields a consistent voltage sag profile for tuning gearing and timing. Always balance-charge using a charger configured for 2S LiPo and the 2mm balance connector supplied.

Specifications

  • Item: Li-Po race pack (hard case with pin)
  • Material: Lithium Polymers
  • Model Number: IP-CC2S3800V3-35C
  • Voltage: 7.4V
  • Capacity: 3800mAh
  • Discharge Rating: 35C
  • Connector Discharge: 4mm pin
  • Connector Balance: 2mm pin
  • Pack Dimension: 137.8 x 46.8 x 23.3 mm
  • Color: Black

This Intellect hard-case 2S Li-Po is aimed at racers who want a mid-capacity pack with predictable discharge; check fitment and connector compatibility with your chassis and charging equipment before racing.

If your vehicle uses a different discharge lead, use a correct-gauge adapter or replace the pins professionally. Avoid jury-rigged connections that add resistance or heat.
Route the 2mm balance lead away from drive shafts, gears, and hot components. Secure it with tape or a clip so it cannot snag during suspension movement or steering travel.
The rigid shell offers good protection for routine pit handling and tie-downs, but inspect for cracks or crushed sections after impacts and replace the pack if internal cell damage is suspected.
Yes, provided the tray dimensions suit 137.8 x 46.8 x 23.3 mm and you can accommodate the pin connectors. Double-check side-to-side and height clearance before final installation.

Copyright © 2008-2026 rcjaz.com.au All rights reserved