Tamiya 56357 Mercedes-Benz Arocs 3348 6x4 Bearing Refresh Pack - JAZRIDER JR-CBR-TM-067 36pcs, off-road ready  [JR-CBR-TM-067]

Tamiya 56357 Benz Arocs 3348 6x4 Tipper Truck Metal Shielded RC Ball Bearing Set Complete 36pcs Jazrider
Price:
AUD$19.28
Brand:
JAZRIDER
Model:
JR-CBR-TM-067
Condition:
Brand New
Available in warehouse
2 Reviews
Write a review

Bearer refresh for Tamiya 56357 Arocs 3348 6x4

The JAZRIDER JR-CBR-TM-067 metal shielded ball bearings are a practical upgrade for the Tamiya 56357 Mercedes-Benz Arocs 3348 6x4 tipper truck. This 36-piece pack replaces factory bearings to restore smooth rotation and improve reliability on rough terrain.

Included bearing sizes

Contents are tailored to common rotating positions on the truck chassis:

  • 8pcs: 6 x 12 x 4mm
  • 27pcs: 5 x 11 x 4mm
  • 1pc: 5 x 8 x 2.5mm

These bearings match wheel hubs, drive shafts and other moving parts, cutting friction and delivering steadier performance.

Practical advantages of metal shields

Compared with plastic shields, metal-shielded bearings resist damage from dust and small debris better. That makes them a sensible choice if you run on dirt, gravel or building sites where contamination is common.

 

Product Reviews
2 Reviews
rating
I ordered a few items and they arrived a day later from delivery date. But that’s understandable in Covid times. rcjaz are great to deal with and will trade with them in the future.
rating
After I was able to establish that I had a problem with an electronic component that was not obvious until it was installed in the model truck, (which was after the “half month” time frame allowed from time of purchase for return and replacement,) whi

Will shafts need modification to fit these bearings?

These bearings are sized to match common factory locations. In most cases they press in without modification, but always verify fit before full installation.

Are these bearings sealed for wet use?

Metal shields offer solid protection against dust and grit but are not fully waterproof. Avoid prolonged water exposure and dry bearings after wet runs.

Do I need special tools to install them?

A bearing press or a soft-fit driver is recommended to seat bearings without damaging the race. Hand tools can work if used carefully.

Copyright © 2008-2025 rcjaz.com.au All rights reserved