These RC-scale front upper suspension arms are intended for the Kyosho Fazer Mk2 FZ02 on-road platform and come finished in red anodized aluminum as shown in the product name. They act as a direct replacement or an aftermarket hop-up for the front upper arm locations on that chassis.
Installation is familiar territory for those experienced with on-road setups: remove the original plastic arms, check that the replacement seats correctly on the factory hinge pin and upright, and transfer any required hardware like spacers or pins. Always confirm suspension geometry after fitting to preserve intended toe and camber settings.
In tuning practice this component is used to stiffen the front end and improve longevity relative to plastic arms; material changes influence steering return and response to driver inputs, so alter setup gradually. Periodic inspection of pivot points and hinge pins will keep handling predictable.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
