Jazrider JR-HAG-TX450-011 Glass Tail Rotor Set for Align Trex 450 SE V2  [JR-HAG-TX450-011]

Glass Fiber Tail Rotor Blade (Yellow with Black) Parts For Align Trex T-Rex 450 SE V2 Helicopter - Jazrider Brand [JR-HAG-TX450-011]
Price:
AUD$12.87
Brand:
JAZRIDER
Model:
JR-HAG-TX450-011
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Tail Rotor Blades for Sport Flying

Replace worn parts on your Align Trex T-Rex 450 SE V2 with Jazrider JR-HAG-TX450-011 glass fiber tail rotor blades designed for consistent performance. The yellow and black pattern not only looks sharp but improves tracking during distance flights.

Material and Fit Details

The glass fiber build provides the strength to withstand regular use while allowing controlled flex. The finish increases visibility in the sky. Blade dimensions are 60mm length and 18mm width with a 2.0mm hole diameter to match the 450 SE V2 mounting.

Handling Benefits and Weight

At about 3 grams per blade, the low weight helps maintain tail agility and reduces load on the tail assembly. These blades suit pilots refining tail tuning or swapping in a fresh set for regular flying.

Mount blades with the rotor centered and verify both blades sit flush. Rotate slowly by hand to confirm equal clearance and then check pitch symmetry with the tail pitch link.
Their low mass reduces continuous load on the servo, so with correct setup they should not increase wear. Use good quality servos and avoid excessive trimming while flying.
Inspect the blades for cracks, splintering or permanent bends. Even small damages can compromise control, so replace any suspect blade before the next flight.
They are designed to be a direct fit for Align Trex 450 SE V2 dimensions, but always confirm mount hole diameter and spacing before final installation.

Copyright © 2008-2026 rcjaz.com.au All rights reserved