KC10 Centre Drive Shaft Upgrade for L77.7 / L64.7 - Kyosho CL011  [KY-CL011]

Kyosho CL011 - Center Shaft (KC10/L77.7/L64.7 1pc each)
Price:
AUD$47.23
Brand:
Kyosho
Model:
KY-CL011
GTIN:
4548565513062
Condition:
Brand New
Write a review

Tuning and replacement notes

Identified as Kyosho CL011, this centre shaft fits KC10 chassis arrangements including the L77.7 and L64.7 formats. It is supplied as a single item (1pcs) and serves as a replacement component in the centre drive assembly for KC10-based RC models.

Install the shaft when preparing the car for setup changes, after component fatigue, or following damage. This is a workshop part for RC servicing and should not be used on full-size vehicles.

Fitting tips: confirm compatibility with your KC10 variant and the listed sub-layouts, align bearings and gear mesh precisely, and manually check that the drive train turns freely after installation. Regular checks will secure proper clearance and seating.

A practical centre drive replacement that helps maintain tuning consistency and get KC10 models back on track.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will swapping this shaft affect my setup?

Replacing a worn shaft restores intended geometry. If the replacement is fitted with correct gear mesh and bearings, your prior setup settings should remain valid.

Does this come as a single replacement piece?

Yes, the listing supplies one piece per purchase, shown as 1pcs in the product description.

Any special setup steps after replacement?

After fitting, recheck gear mesh, bearing preload, and drive alignment; then perform a slow test run to confirm smooth rotation and no unexpected handling changes.

Will a new shaft change drivetrain noise?

A correctly fitted new shaft typically reduces noise caused by wear. If noise persists, re-evaluate gear mesh and bearing seating.

Copyright © 2008-2026 rcjaz.com.au All rights reserved