KC10 DIG Switch Conversion for Remote Operation - CLW002 Kyosho  [KY-CLW002]

Kyosho CLW002 - Dig Kit (KC10)
Price:
AUD$44.69
Brand:
Kyosho
Model:
KY-CLW002
GTIN:
4548565515875
Condition:
Brand New
Write a review

KC10 remote DIG conversion

The Kyosho CLW002 Dig Kit is an accessory for KC10 transmissions that enables DIG activation from the radio via an extra channel. When triggered, the DIG feature locks the rear drive while the front remains driven, allowing a much tighter turning arc than standard setup.

This kit adapts the transmission's built-in DIG mechanism to be controlled from the transmitter, removing the need to fiddle with onboard manual switches. Typical installation maps the DIG function to an auxiliary switch so drivers can enable it for tight turns or obstacles during runs.

Installation summary: the kit connects to the DIG actuator and requires wiring to the receiver or a switch harness, plus an available transmitter channel. Due to variations in KC10 builds and wiring layouts, check the chassis manual and confirm whether your model already includes DIG before proceeding.

Fitted to KC10 cars, the CLW002 Dig Kit delivers selectable rear-drive locking that helps reduce steering corrections and tighten cornering lines.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is the CLW002 compatible with all KC10 variants?

The kit is intended for KC10 transmissions featuring a DIG mechanism. Verify your specific KC10 model and consult the chassis documentation to ensure compatibility before ordering.

What wiring is required to fit this kit?

Basic wiring from the kit to the receiver or switch harness is needed and an empty auxiliary channel on the transmitter; follow the KC10 wiring diagram for correct connections.

Will the kit need servo power or a separate battery?

The CLW002 uses the vehicle's existing receiver power and a spare channel signal; no separate power source is typically required beyond the model's normal electronics supply.

Can I retrofit the kit myself?

Enthusiasts with basic soldering or connector skills can fit the kit, but follow the KC10 service manual and wiring notes carefully; seek help if unsure about the vehicle's electronics layout.

Copyright © 2008-2026 rcjaz.com.au All rights reserved