K&S KS2443 M2.6x10 Servo Tapping Screw Set 20pcs  [KS2443]

K&S SOCKET HEAD SERVO TAPPING SCREW M2.6X10 20PCS #2443
Price:
AUD$5.42
Brand:
K&S
Model:
KS2443
Condition:
Brand New
Write a review

Details and Use Cases for K&S KS2443

This K&S KS2443 pack contains twenty M2.6x10 socket head tapping screws for scale RC servo mounting and small assemblies. The slim head profile frees up clearance around servo arms and linkage areas, while the thread form is intended to cut into plastics and thin metals used on many model parts.

Tuning note: when fine adjustments to servo position are important, use the correct screw length and tighten incrementally to avoid altering horn geometry or binding linkages. Start each screw straight, and complete final seating by hand to control torque on delicate plastic pieces.

Application note: sized for M2.6 tapped holes found on many servo horns, plastic mounting plates, and aftermarket accessories, these screws serve as a handy replacement set for model electrics and scale builds.

Packing includes

  • Socket head tapping screws M2.6x10 - 20 pcs

Will using these screws change servo alignment during tuning?

If over-tightened, plastic horns can deform and affect neutral position. Tighten gradually, check servo centering after installation, and back off slightly if any binding or misalignment is detected.

How do I choose the correct screw length for my horn?

Measure the thickness of the horn plus mounting surface and allow a small thread engagement without the screw bottoming out. When in doubt, test with a single screw and inspect the underside before fitting the remainder.

Copyright © 2008-2026 rcjaz.com.au All rights reserved