Kyosho 39215LWB Non-Decoration Audi R8 LMS 2015 Body for FAZER Mk2 FZ02  [KY-39215LWB]

Kyosho 39215LWB - AUDI R8 LMS 2015 Non-Decoration Body Set(Put/Light Weight)
Price:
AUD$84.54
Brand:
Kyosho
Model:
KY-39215LWB
GTIN:
4548565526994
Condition:
Brand New
Write a review

Audi R8 LMS 2015 light shell for on-road testing

Produced by Kyosho, this non-decoration, light weight body set models the AUDI R8 LMS 2015 and is made for FAZER Mk2 FZ02 on-road chassis compatibility. The shell comes unpainted and without decals, so painting, trimming, and preparation are required before running.

Hobbyists will value the blank surface for custom paint and aerodynamic trials; the reduced mass aims to give a different baseline for setup compared with heavier shells. It is intended as a direct-fit alternative for FAZER Mk2 FZ02 compatible arrangements and for evaluating aerodynamic changes on on-road circuits.

Installation notes: this is an uncut body that requires trimming, painting, and proper mounting to the chassis body posts. Always test-fit to FAZER Mk2 FZ02 mounting locations and check for steering and suspension clearance during preliminary installs.

Product Specifications

  • Item: AUDI R8 LMS 2015 Non-Decoration Body Set
  • Material: Light weight
  • Model Number: 39215LWB
  • Compatibility: FAZER Mk2 FZ02

This raw, light weight shell functions as a practical test platform for aerodynamic tuning and weight distribution work on FAZER Mk2 FZ02 on-road vehicles, allowing for bespoke finishing and setup changes.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What basic tools are recommended to prepare this unpainted shell?

A sharp hobby knife, fine-grit sandpaper, a hole punch or small drill for mounts, and polycarbonate-safe paint are the essentials. Use low-tack tape when marking cutting lines.

Is this body compatible with other FAZER variants?

The shell is specified for FAZER Mk2 FZ02. Other FAZER variants may differ in post locations; always test-fit before committing to trimming on alternate chassis.

How should the shell be secured to body posts?

After aligning and trimming, secure the shell with standard body clips or screws as used on your FAZER Mk2 FZ02. Avoid overtightening which can stress the material.

Any quick checks before the first run?

Confirm that steering reaches full lock without rubbing and that suspension travel is unobstructed. Inspect mount points and clearances after painting and before track use.

Copyright © 2008-2026 rcjaz.com.au All rights reserved