Kyosho A1271-13R Red Replacement Horizontal Stabilizer for Calmato Alpha 40  [KY-A1271-13R]

Kyosho A1271-13R - Horizontal Stabilizer (Calmato Alpha 40 Red)
Price:
AUD$138.97
Brand:
Kyosho
Model:
KY-A1271-13R
GTIN:
4548565503575
Condition:
Brand New
Write a review

Replacement stabilizer built for Calmato Alpha 40 airframes

This horizontal stabilizer is supplied as a direct replacement tailplane for Calmato Alpha 40 RC planes. It restores the correct mounting area and aero profile for the elevator and is intended for use during repairs, maintenance, or when swapping out a damaged original.

Installation and setup notes:

  • Verify hinge alignment and the stabilizer centerline before the adhesive fully cures; correct alignment preserves a neutral elevator position.
  • Check control horn and linkage geometry to ensure full, symmetrical travel without binding; adjust clevises or linkage length as needed to reach recommended neutral and throw values.
  • Bench-test servo response and elevator travel after fitting and before first flight to confirm direction and endpoint settings.
  • Keep the stabilizer stored flat and away from heat to prevent warping; inspect hinges and attachment points after impacts or hard landings.

Specifications

  • Part type: Horizontal stabilizer
  • Compatibility: Calmato Alpha 40 RC airplane series
  • Color: Red finish
  • Includes: 1pc
  • Function: Replacement tailplane for pitch stability and trim

Carry a spare stabilizer to cut down on field repairs - use this component for maintenance, crash repairs, or when matching finish and geometry during a rebuild.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this stabilizer fit a different Calmato variant?

The part is made for the Calmato Alpha 40 range. Compatibility with other variants depends on the fuselage mounting and hinge spacing, so check measurements before installation.

What does the package contain?

You will receive one horizontal stabilizer finished in red, sized for the Calmato Alpha 40. Additional hardware is not included unless noted by the supplier.

Do I need to modify it before fitting?

The stabilizer is supplied with a red finish; small trimming of mounting tabs or clearing hinge slots may be needed for a precise fit to your airframe.

How should I verify alignment after install?

Confirm the stabilizer is level with the fuselage centerline, check elevator neutral with the servo centred, and ensure equal travel each side with trims neutral.

When is replacement necessary?

Replace the stabilizer after visible cracks, warping, or when repairs no longer restore the correct geometry and surface strength.

Copyright © 2008-2026 rcjaz.com.au All rights reserved